I have an older version of Navigatrix loaded on the CF-28, 0.4.1202
and xinput_calibrator comes preloaded. When this is run in terminal, the output looks like this:
tank@tank-laptop:~$ xinput_calibrator
Calibrating EVDEV driver for "LBPS/2 Fujitsu Lifebook TouchScreen" id=11
current calibration values (from XInput): min_x=152, max_x=3840 and min_y=318, max_y=3859
Doing dynamic recalibration:
Setting new calibration data: 159, 3834, 315, 3859
--> Making the calibration permanent <--
Install the 'xinput' tool and copy the command(s) below in a script that starts with your X session
xinput set-int-prop "LBPS/2 Fujitsu Lifebook TouchScreen" "Evdev Axis Calibration" 32 159 3834 315 3859
tank@tank-laptop:~$
Which is different from this posting:
viewtopic.php?f=39&t=1960
Jeff's output from that post is this:
Section "InputClass"
Identifier "calibration"
MatchProduct "Fujitsu Component USB Touch Panel"
Option "Calibration" "303 4000 258 3917"
Option "SwapAxes" "0"
EndSection
My question is in regards to my output when xinput_calibrator runs, as besides my four sets of numbers, there is a "32" in front of the other four cal values. Hmmmmmm? i.e. mine does not have Section, end of section, etc. PS, my version of xinput = 1.5.0