To save repeating myself.....
http://forum.notebookreview.com/panason ... 1-too.html
Thanks,
Jeff
CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
Fair for you/ Fair for me.
I chose to NOT be organized.
-------------------------------------------------------------------[/color]
http://toughbooktalk.com/
http://forum.notebookreview.com/panasonic/
I chose to NOT be organized.
-------------------------------------------------------------------[/color]
http://toughbooktalk.com/
http://forum.notebookreview.com/panasonic/
Re: CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
(Incase NBR IS DOWN)
Model number doesn't matter but just for drill CF-30CTQCTBM.
I recently installed Mint 15 on my CF-30 MK3. Made the tweaks for Touchscreen and have been running it for days.
Today while working on this MK1 with a known defective Touchscreen I used the drive from the MK3. Worked great....I thought.
With a new touch panel I was getting errors with Calibrate_Touchscreen.
Long story short I found the caddy for this unit and ran it. Touch was near perfect. Back to the MK3 caddy and it was off.
So....looking at the numbers it finally came to me....these are TOUCHSCREEN numbers. TABLET numbers are a lot lower.
Section "InputClass"
Identifier "calibration"
MatchProduct "Fujitsu Component USB Touch Panel"
Option "Calibration" "1718 15600 1905 15685"
EndSection
And this is a XP Bios....TOUCHSCREEN not TABLET. Bios and ec 20/17.
What I'm getting at is this:
For the Mark 1 (only) delete /etc/X11/xorg.conf.d/99-calibration.conf and start over with calibration if you are swapping drives from a higher mark and getting errors.
As I figure it, the OS reads the 99-calibration.conf when loading the drivers (you told it to) and then reports numbers out of range. Typical computer behavior......completely logical.
Side note: CF-19 Mark 1 is like this too?
Little bit more....If swapping drives and the XP bios is not needed set the CF-30 MK1 to the Vista bios and ignore this.
EDIT:
Here's the numbers after swapping back to MK3 which thinks it's a tablet. The lower set. Copied from /etc/X11/xorg.conf.d/99-calibration.conf. I didn't delete the file thiis time...just ran calibration until the cursor touched where I was inputting. (five times I think) Believe it works this way since the Tablet numbers are inside the range of the Touchscreen numbers.
#Section "InputClass"
# Identifier "calibration"
# MatchProduct "Fujitsu Component USB Touch Panel"
# Option "Calibration" "1718 15600 1905 15685"
#EndSection
Section "InputClass"
Identifier "calibration"
MatchProduct "Fujitsu Component USB Touch Panel"
Option "Calibration" "303 3884 274 3949"
EndSection
END EDIT.
Model number doesn't matter but just for drill CF-30CTQCTBM.
I recently installed Mint 15 on my CF-30 MK3. Made the tweaks for Touchscreen and have been running it for days.
Today while working on this MK1 with a known defective Touchscreen I used the drive from the MK3. Worked great....I thought.
With a new touch panel I was getting errors with Calibrate_Touchscreen.
Long story short I found the caddy for this unit and ran it. Touch was near perfect. Back to the MK3 caddy and it was off.
So....looking at the numbers it finally came to me....these are TOUCHSCREEN numbers. TABLET numbers are a lot lower.
Section "InputClass"
Identifier "calibration"
MatchProduct "Fujitsu Component USB Touch Panel"
Option "Calibration" "1718 15600 1905 15685"
EndSection
And this is a XP Bios....TOUCHSCREEN not TABLET. Bios and ec 20/17.
What I'm getting at is this:
For the Mark 1 (only) delete /etc/X11/xorg.conf.d/99-calibration.conf and start over with calibration if you are swapping drives from a higher mark and getting errors.
As I figure it, the OS reads the 99-calibration.conf when loading the drivers (you told it to) and then reports numbers out of range. Typical computer behavior......completely logical.
Side note: CF-19 Mark 1 is like this too?
Little bit more....If swapping drives and the XP bios is not needed set the CF-30 MK1 to the Vista bios and ignore this.
EDIT:
Here's the numbers after swapping back to MK3 which thinks it's a tablet. The lower set. Copied from /etc/X11/xorg.conf.d/99-calibration.conf. I didn't delete the file thiis time...just ran calibration until the cursor touched where I was inputting. (five times I think) Believe it works this way since the Tablet numbers are inside the range of the Touchscreen numbers.
#Section "InputClass"
# Identifier "calibration"
# MatchProduct "Fujitsu Component USB Touch Panel"
# Option "Calibration" "1718 15600 1905 15685"
#EndSection
Section "InputClass"
Identifier "calibration"
MatchProduct "Fujitsu Component USB Touch Panel"
Option "Calibration" "303 3884 274 3949"
EndSection
END EDIT.
CF-28 MK2,Mk3 / CF-29 Mk3 / CF-30 MK2 / CF-25 Mk1 ATI / CF-19 MK3/Mk3/Mk5 / CF-U1 Mk1,Mk2 / CF-M34 Mk7/Mk3 / CF-17 Mk1 / CF-07
Voodoo Envy M355 / M360 / M515 / M780 / U703 / Voodoo Hexx / Voodoo Idol / Voodoo Rage F1 / Voodoo Rage F1 / Voodoo Rage F1 "signed case" / Voodoo Omen
Alienware M11x R1, Alienware 17 R5
Voodoo Envy M355 / M360 / M515 / M780 / U703 / Voodoo Hexx / Voodoo Idol / Voodoo Rage F1 / Voodoo Rage F1 / Voodoo Rage F1 "signed case" / Voodoo Omen
Alienware M11x R1, Alienware 17 R5
Re: CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
ADOR wrote:(Incase NBR IS DOWN)
![:lauging: :lauging:](./images/smilies/laughing4.gif)
![:lauging: :lauging:](./images/smilies/laughing4.gif)
![:lauging: :lauging:](./images/smilies/laughing4.gif)
![:lauging: :lauging:](./images/smilies/laughing4.gif)
![:blowaway: :blowaway:](./images/smilies/rocketwhore.gif)
![:blowaway: :blowaway:](./images/smilies/rocketwhore.gif)
![:blowaway: :blowaway:](./images/smilies/rocketwhore.gif)
![:sucks: :sucks:](./images/smilies/sucks.gif)
~Rob - Vice President - Rugged Depot~
~Cell: (630)/300-8877~
~Owner - Toughbooktalk~
~Fully rugged Toughbook user since April 18th 2005~
~FZ-40ACAAHKM - Primary Toughbook / Workstation as of 7/29/22
~Win10 Pro (Win11 DG), Intel Core i5-1145G7 (up to 4.4GHz), vPro, 14.0" FHD Gloved Multi Touch, 16GB, 1TB Samsung SSD, Intel Wi-Fi 6, Bluetooth, 4G EM7690, GPS, Quad Pass (BIOS Selectable), Mic and Infrared 5MP Webcam, Standard Battery, TPM 2.0, Emissive Backlit Keyboard, Dual Batteries, USB A + HDMI + Serial X-PAK, Shoulder Strap, Flat~
~AT&T Business 1GB Fiber 1GB/1GB business static line~
~Gamber & Johnson Platinum Partner~
http://www.toughbooktalk.com
http://downloads.toughbooktalk.com/
http://www.rugged575.com - 300' UHF GMRS Radio Repeater
http://www.crete600.com - 310' UHF Linked GMRS Radio Repeater
~Emergency preparedness starts with reliable communication systems above all. Pretend the internet and cell phones didn’t exist, how will you communicate? If you’re interested in learning more, ask me!~
~Cell: (630)/300-8877~
~Owner - Toughbooktalk~
~Fully rugged Toughbook user since April 18th 2005~
~FZ-40ACAAHKM - Primary Toughbook / Workstation as of 7/29/22
~Win10 Pro (Win11 DG), Intel Core i5-1145G7 (up to 4.4GHz), vPro, 14.0" FHD Gloved Multi Touch, 16GB, 1TB Samsung SSD, Intel Wi-Fi 6, Bluetooth, 4G EM7690, GPS, Quad Pass (BIOS Selectable), Mic and Infrared 5MP Webcam, Standard Battery, TPM 2.0, Emissive Backlit Keyboard, Dual Batteries, USB A + HDMI + Serial X-PAK, Shoulder Strap, Flat~
~AT&T Business 1GB Fiber 1GB/1GB business static line~
~Gamber & Johnson Platinum Partner~
http://www.toughbooktalk.com
http://downloads.toughbooktalk.com/
http://www.rugged575.com - 300' UHF GMRS Radio Repeater
http://www.crete600.com - 310' UHF Linked GMRS Radio Repeater
~Emergency preparedness starts with reliable communication systems above all. Pretend the internet and cell phones didn’t exist, how will you communicate? If you’re interested in learning more, ask me!~
Re: CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
I like spearmint....
Life will beat you into submission.
Re: CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
32 or 64 bit?Shawn wrote:I like spearmint....
![:boing: :boing:](./images/smilies/toothy9.gif)
CF-29LTQ,CF-31SBM,CF-52youngGUN,
Life's Journey is not to arrive safely at the grave in a well preserved body, but rather to skid in sideways totally worn-out shouting 'Woo Hoo! What a ride!
Motorsports - the only real sport. If it doesn't have a motor, it is just a game.
There is always something waiting at the end of the road, if you are not willing to see what it is, you probably shouldn't be out there in the first place.
Life's Journey is not to arrive safely at the grave in a well preserved body, but rather to skid in sideways totally worn-out shouting 'Woo Hoo! What a ride!
Motorsports - the only real sport. If it doesn't have a motor, it is just a game.
There is always something waiting at the end of the road, if you are not willing to see what it is, you probably shouldn't be out there in the first place.
Re: CF-30 Mark 1 XP Bios with Mint 15.....link to NBR Post.
Wrigley's
Of course it's 32 bit or is that 32 bite as in 32 teeth...
Of course it's 32 bit or is that 32 bite as in 32 teeth...
Life will beat you into submission.